Readme File
===========

This file contains additional information to supplement the manual.
Please read all the sections before you proceed with the installation
of your PCI card.

    1.   Changing the Interrupt Request (IRQ) Setting
    2.   Tips on Installation


1.  CHANGING THE INTERRUPT REQUEST (IRQ) SETTING
    ============================================

    If you want to change an IRQ setting for a PCI card, it is best
    to do so from the BIOS setup screen.

    The reason: PCI cards are configured differently from ISA
                cards; unlike ISA cards, it is usually not
                possible to change the IRQ for a PCI card from
                the operating system.

    ------------------------------------------------------------------
    CAUTION: Do not change the BIOS settings unnecessarily unless
             you are skilled in it, as meddling with the BIOS
             settings may hang the system or slow down the system
             performance. Record all BIOS settings prior to making
             any changes to ensure you can return to your original
             settings.
    ------------------------------------------------------------------

    To access the BIOS setup screen:
       a. At system startup, press the key or key combination (often
          just the Delete or Esc key) as required by your motherboard.

    NOTE: For more directions on entering your BIOS and an explanation
          about what each BIOS setting means, refer to your motherboard
          manual.

    The IRQ resource is typically found in the PNP/PCI Configuration
    Setup section.

    Under this section, there is an option to assign PCI slots to
    "Auto" or "Manual" to set an IRQ. This option is typically
    called Resources Controlled By or PNP/PCI BIOS Auto-Config.

    To change an IRQ, you need to set this option to "Manual" or
    "Disabled".

    Some BIOSes only allow you to define which IRQs are not to be used
    and will in turn assign another available IRQ automatically, while
    some BIOSes allow you to select the IRQs to be used for a
    particular PCI slot.

    For example, with a certain type of BIOS:
    To change the IRQ setting for your PCI card from the current IRQ 11:
       a. At Resource Controlled By option, switch to "Manual".
       b. Change the setting in IRQ-11 option to "Legacy ISA".
          This means that the BIOS will assign an available IRQ
          other than IRQ 11 to the PCI audio card.
       c. Save these new settings and exit the BIOS.

    Another example on a different type of BIOS:
    If your PCI audio card is plugged into slot 1, your PCI video card
    in slot 3, and both cards are using IRQ 11, to change the IRQ setting
    for your PCI audio card from current IRQ 11:
       a. At the BIOS Auto-Config option, switch to "Disabled".
       b. Change the setting in slot 1 option to another available
          interrupt.
       c. Save these new settings and exit the BIOS.

    NOTE: For more information on BIOS setting or Slot 1 location,
          refer to your BIOS or motherboard manual.


2.  TIPS ON INSTALLATION
    =====================

    When your operating system asks for the PCI drivers, click the
    Browse button, go to the root directory of the d: drive
    and click OK.

    If the files cannot be found, browse to the d:\os\language\DRIVERS
    directory and click OK.

    NOTE: Where "d" is your CD drive letter, "os" is the operating system
          on which you are running, and "language" is the language of the
          software you want to install.

    Once you are in that directory, the installation engine should be able
    to find all the necessary files.


                          *** End of Readme ***