Video Blaster MP400
CT6080
Video Blaster MP400 MPEG I Decompression card is a MPEG I video/audio
decoder board designed for real-time playback of MPEG I compressed
full-motion pictures.
- System Requirements:
- 386 DX33 and above
- 4MB system memory
- Free 16-bit ISA slot
- CD-ROM drive
- DOS 3.0 and above
- Windows 3.1 installed
- Vido Playback Specifications:
- MPEG Video Standard: ISO-11172 MPEG I standard
- Frame Rate Support: 30fps (NTSC), 25fps (PAL), 24fps (Film)
- Output Display: VGA resolution supported is 640x480
- Audio Playback Specifications:
- MPEG Audio Standard: ISO-11172 MPEG I Layer II audio standard
- Sampling Frequency: 44.1 KHz
- Volume Control: 0 dB to 64 dB in steps of 2 dB
- Supply Voltage Requirement (Loading): +5, +12, -12 Volt
- Current Consumption (Typical.): 1100, 600, 150 mA respectively
- Audio Power Amplifier Output Level: 1.5 Watts maximum per
channel with 4-Ohm load
- Audio Line Out Output Level: 0.7 Vrms maximum per channel
with 47K-Ohm load
- Video Signal Input Level: 0.7 Vpp (typical)
- Video Signal Output Level: 0.7 Vpp (typical)
Default settings shown in [brackets]
- Interrupt (IRQ): 5, 10, 11, 12, [15]
- DMA channel: 5, 6, [7]
- I/O Address: 240, 280, [2C0], 300, 340, 380 Hex
- VGA In Connector - 15 pin D-shell female connector
- Monitor Out Connector - 15 pin D-shell female connector
- Audio Line Out Connector - Phono jack socket, stereo, 3.5mm
diameter
- Speaker Out Connector - Phono jack socket, stereo, 3.5mm diameter
- VGA Feature Connector - 26 way double row straight header
Copyright ©1995, 1996
Creative Labs, Inc.