Video Blaster RT300
CT6061
Video Blaster RT300 is a single-step, real time video capture
and compression board, based on the Intel i750PE pixel processor.
It has the power to capture video from number of sources, including
video cameras, VCRs and video disc, at a resolution up to 320x240
@ 15fps, or 160x120 @ 30fps depending on the system used. PAL,
NTSC and SECAM standards are supported and can be automatically
detected by the software. Inputs for both composite video and
S-Video are provided.
- System Requirements:
- IBM PC 386 DX33 and above
- 4MB system memory
- 2MB hard drive space, minimum
- 16-bit ISA expansion slot
- MS DOS 3.1 or PC DOS version 5.0 and above
- Windows 3.1 or higher installed
- MS Video For Windows 1.1D and above
- Interlace and Non-Interlace Supported
- AD/DA Resolution: 8-bits resolution; sampling rate at 32 MHz
- Supply Voltage Requirement (Loading): +5, +12 Volt
- Current Consumption (Typical.): 450, 50 mA respectively
- Clocks Frequency: 50 MHz and 26.8 MHz
- Video Signal Input Level:
- Composite video signal: 1.0 Vpp @ 75-Ohm load
- S-Video signal: 1.0 Vpp (nominal)
- Video Signal Output Level: YUV 4:1:1 output data format
Default settings shown in [brackets]
- Interrupt (IRQ): 9, [10], 11, 12
- I/O Address: 280, 2A0, 2D0, [2E4], 340, 3A0, 3E0 Hex
- 3 RCA Video-In Connectors
Copyright ©1995, 1996
Creative Labs, Inc.