Video Blaster SE

CT6040

Video Blaster SE (Special Edition) is a video adapter for PC386 and higher compatibles which converts a standard full-motion video image (composite video source) into a format for display on a computer graphics monitor. It can position and scale the video image onto the output display and allows the video image to be merged with computer graphics for interactive multimedia applicaiton. VB SE supports both NTSC and PAL system. VB SE has to work with standard VGA card that incorporates a feature connector. It accepts composite video and S-Video; caters 3 composite video inputs (video 0, 1, 2) or 1 composite video inputs and 1 S-Video source using special S-Video adapter cable.

• General
• Hardware Specifications
• Hardware Settings
• External Connectors

GENERAL

• System Requirements:
  • IBM PC 386 DX33 and above
  • 4MB system memory
  • 2MB hard drive space, minimum
  • 16-bit ISA expansion slot
  • MS DOS 3.1 or PC DOS version 5.0 and above
  • VGA card with standard VESA compliant feature connector
  • Windows 3.1 or higher installed
  • MS Video For Windows 1.0 and above
• Interlace and Non-Interlace Supported
• AD/DA Resolution: 8-bits resolution; sampling rate at 32 MHz

HARDWARE SPECIFICATIONS

• Supply Voltage Requirement (Loading): +5, +12, -12 Volt
• Current Consumption (Typical.): 1, 0.28, 0.104 A respectively
• Clocks Frequency: 50 MHz and 26.8 MHz
• Video Signal Input Level:
  • Composite video signal: 1.0 Vpp @ 75-Ohm load
  • S-Video signal: 1.0 Vpp (nominal)
• Video Signal Output Level: RGB 0.6 Vp-p (typical)

HARDWARE SETTINGS

• Interrupt (IRQ): 5, [10], 11, 12, 15
• I/O Address (s/w programmable): 690, 6E0, 710, [718], 780 Hex

EXTERNAL CONNECTORS

• VGA/Video In Connector - 15 pin D-shell female connector
• Monitor Out Connector - 15 pin D-shell female connector
• VGA Feature Connector - 26 way double row straight header