Video Capture/CODEC Card

CTS7020

• General
• Hardware Specifications
• Hardware Settings
• External Connectors

GENERAL

• System Requirements:
  • IBM PC 486 DX33 and above
  • 8MB system memory
  • 16-bit ISA expansion slot
  • MS DOS 3.1 or PC DOS version 5.0 and above
  • Windows 3.1 or higher installed
  • MS Video For Windows 1.1D and above
• Interlace and Non-Interlace Supported
• No DMA capability supported
• On-board Memory size: 1/2 MBytes DRAM

HARDWARE SPECIFICATIONS

• Supply Voltage Requirement (Loading): +5, +12 Volt
• Current Consumption (Typical.): 1200, 600 mA respectively
• Clocks Frequency: 28.322 MHz and 26.8 MHz
• Signal Input Level: 0.7 Vpp (typical)
• Signal Output Level: Not Applicable

HARDWARE SETTINGS

• Interrupt (IRQ): [10], 11, 12, 15 - s/w configurable
• I/O Address: 250, [2D0], 2E0, 310, 330, 350, 390 Hex - s/w configurable

EXTERNAL CONNECTORS

• S-Video In Connector - 4 pin S-connector
• 2 x RCA Video In Connector - Composite video